PANASONIC ==> KX-TDE100/KX-TDE200

KX-TDE 100/200 Feature Manual
Introduction | A | B | C | D | E | F | G | H | I | L | M | O | P | Q | R | S | T | U | V | W |

2.3 Supported Management Information Base (MIB) Table

System Group (1.3.6.1.2.1.1)

Object ID

Item

Description

1
sysDescr
Information of Hardware type and Software version of the Device.
2
sysObjectID
Object identifier of this product.
3
sysUpTime
Elapsed time since the system was restarted.
4
sysContact
Device Administrator.
5
sysName
Name of Device.
6
sysLocation
Installation Location of Device.
7
sysService
Support Layer.
Interface Group (1.3.6.1.2.1.2)

Object ID

Item

Description

1
ifNumber
The number of Network Devices.
2
IfTable (NA)
Management Table by each Network Device.
2.1
IfEntry (NA)
Components of ifTable.
2.1.1
ifIndex
Each interface identifier.
2.1.2
ifDescr
Explanation of Interface.
2.1.3
ifType
Type of Interface.
2.1.4
ifMtu
Maximum Datagram Length which can be sent/received.
2.1.5
ifSpeed
Maximum Transfer Speed.
2.1.6
ifPhysAddress
Physical Address (MAC Address).
2.1.7
ifAdminStatus
The desired state of the interface.
2.1.8
ifOperStatus
The current operational state of the interface.
2.1.9
ifLastChange
The value of sysUpTime at the time the interface entered its current operational state (up or down).
2.1.10
ifInOctets
The number of Octets received.
2.1.11
ifInUcastPkts
The number of Unicast Packets delivered to a higher-layer protocol.
2.1.12
ifInNUcastPkts
The number of Non Unicast Packets delivered to a higher-layer protocol.
2.1.13
ifInDiscards
The number of inbound Packets which is discarded because of lack of received Buffer.
2.1.14
ifInErrors
The number of inbound Packets that contained errors.
2.1.15
ifInUnKnownProtos
The number of Packet received which are discarded because of an unknown/unsupported protocol.
2.1.16
ifOutOctets
The number of Octets transmitted.
2.1.17
ifOutUcastPkts
The number of Unicast Packets which are received from upper protocol.
2.1.18
ifOutNUcastPkts
The number of Non Unicast Packets which are received from upper protocol.
2.1.19
ifOutDiscards
The number of outbound Packets which are discarded because of lack of transmitted Buffer.
2.1.20
ifOutErrors
The number of outbound packets that could not be transmitted because of errors.
2.1.21
ifOutQLen
The length of the output packet queue (in packets).
2.1.22
ifSpecific
Relevant MIB object identifier.
IP Group (1.3.6.1.2.1.4)

Object ID

Item

Description

1
ipForwarding
The value which indicates operation availability as a router (whether Datagram is transferred or not).
2
ipDefaultTTL
Default value for IP Packet TTL (Time to Live).
3
iplnReceives
The total number of Packets received (including packet received in error).
4
ipnHdrErrors
The number of Packets discarded due to errors in their header.
5
ipInAddrError
The number of Packets discarded because IP Address of the destination was invalid.
7
ipInUnknownProtos
The number of Packets discarded because the protocol was unknown/unsupported.
8
ipInDiscards
The number of incoming Packets discarded because of an insufficient reception buffer.
9
ipInDelivers
The total number of Packets received (including ICMP) normally.
10
ipOutRequests
The total number of IP Packets (ICMP) which are tried to be transmitted (relay Packet is not included).
13
ipReasmTimeout
The maximum number of seconds required in the buffer to rebuild a fragmented Packet.
14
ipReasmReqds
The number of Packets that required rebuilding from a fragmented state.
15
ipReasmOKs
The number of Packets that were rebuilt correctly from a fragmented state.
16
ipReasmFails
The number of Packets that could not be rebuilt correctly from a fragmented state.
17
ipFragOKs
The number of Packets that were fragmented correctly.
18
ipFragFails
The number of Packets that could not be fragmented correctly.
19
ipFragCreates
The number of IP datagrams created due to fragmentation.
20
ipAddrTable (NA)
Management Table of addressing information relevant to this entity's IP addresses.
20.1
IpAddrEntry (NA)
Components of ipAddrTable.
20.1.1
IpAdEntAddr
IP Address.
20.1.2
IpAdEntIfindex
Index value of the Interface which is assigned to IP address.
20.1.3
IpAdEntNetMask
The Subnet Mask associated with IP address.
20.1.4
ipAdEntBcastAddr
Broadcast Address Value associated with IP Address.
20.1.5
IpAdEntReasmMaxSize
The size of the largest IP Datagram which can be sent/received through IP Address.
ICMP Group (1.3.6.1.2.1.5)

Object ID

Item

Description

1
cmpInMsgs
The total number of ICMP messages received (excluded, with error).
2
icmpInErrors
The total number of ICMP messages received which contained error.
8
icmpInEchos
The total number of ICMP echo request messages received.
9
icmpInEchoReps
The total number of ICMP echo answering messages received.
14
icmpOutMsgs
The number of ICMP messages which were sent.
15
icmpOutErrors
The number of ICMP messages which were not sent because of error.
21
icmpOutEchos
The number of ICMP Echo request messages sent.
22
icmpOutEchoReps
The number of ICMP Echo Reply messages sent.
TCP Group (1.3.6.1.2.1.6)

Object ID

Item

Description

1
tcpRtoAlgorithm
The algorithm used to determine the timing of retransmitting when a response was unacknowledged.
2
tcpRtoMin
Minimum value permitted for retransmission timeout (in milliseconds).
3
tcpRtoMax
Maximum value permitted for retransmission timeout (in milliseconds).
4
tcpMaxConn
Maximum number of TCP connections which can be supported.
5
tcpActiveOpens
The total number of Active open TCP connections.
6
tcpPassiveOpens
The total number of Passive open TCP connections.
7
tcpAttemptFails
The total number of connections error.
8
tcpEstabResets
The total number of resets.
10
tcpInSegs
The total number of segments received.
11
tcpOutSegs
The total number of segments sent.
12
tcpRetransSegs
The total number of segments retransmitted.
20
tcpInErrs
The total number of segments received in error.
21
tcpOutRsts
The total number of TCP segments sent containing the RST flag (reset connection).
UDP Group (1.3.6.1.2.7)

Object ID

Item

Description

1
udpInDatagrams
The total number of UDP Datagrams received.
2
udpNoPorts
The total number of received UDP Datagrams for which there was no application at the destination port.
3
udpInError
The total number of received UDP Datagrams which contained error.
4
udpOutDatagrams
The total number of UDP Datagrams sent.
SNMP Group (1.3.6.1.2.1.11)

Object ID

Item

Description

1
snmpInPkts
The total number of SNMP messages received.
2
snmpOutPkts
The total number of SNMP messages sent.
3
snmpInBadVersions
The total number of received SNMP messages of which version is unsupported.
4
snmpInBadCommunityNames
The total number of SNMP messages with unknown Community Name.
6
snmpInASNParseErrs
The total number of SNMP messages with incorrect OID type.
13
snmpInTotalReqVars
The total number of Objects which have been retrieved value successfully.
15
snmpInGetRequests
The total number of Get-Request which have been accepted and processed (e.g. Data extract by using snmpget/snmpwalk command).
16
snmpInGetNexts
The total number of Get-Next which have been accepted and processed (for at the time of following a layer-tree by using snmpwalk command).
20
snmpOutTooBigs
The total number of sent SNMP messages which returned an error of "TooBig".
21
snmpOutNoSuchNames
The total number of sent SNMP messages which returned an error of "NoSuchName".
24
snmpOutGenErrs
The total number of sent SNMP messages which returned an error of "GenErr".
28
snmpOutGetResponses
The total number of GetResponse sent.
29
snmpOutTraps
The total number of TRAP sent.
30
snmpEnableAuthenTraps
Indicates whether the SNMP agent process is permitted to generate authentication failure traps.